Author Topic: SSL 4000 E Cut Problem  (Read 416 times)

Romaphonic

  • Newbie
  • *
  • Posts: 6
  • Karma: +0/-0
SSL 4000 E Cut Problem
« on: December 04, 2018, 04:43:13 PM »
Hi! I m having a problem with the whole console right now... i could not find in the forum if someone had similar issue!

When i start cutting channels... as I accumulate cuts, the remaining channels start losing gain... i tried swaping modules, turning off some bucket, PSU is OK, but cant find the issue...

does anyone have any clue?

thanks as always!!!

bests

N

MarconeMusic

  • Jr. Member
  • **
  • Posts: 83
  • Karma: +0/-0
    • Halomusic.ca
Re: SSL 4000 E Cut Problem
« Reply #1 on: December 14, 2018, 03:34:49 AM »
Do you have led bulbs in the console?
Iíve heard of people with issues with leds that arenít right. 
Only thing I can think of, by enabling more bulbs, more problems

Dunno?

WiktorTRS

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • mazowieckie
Re: SSL 4000 E Cut Problem
« Reply #2 on: January 13, 2020, 10:08:29 AM »
Hi, I have similar issue. I have noticed this during writing automation. When cuts are getting accumulate, levels slightly going down. Even a master fader. I started to use faders instead of cuts. It's annoying... Did you manage the problem?
Kindly regards,
Wiktor

Audioplatinum Service

  • Jr. Member
  • **
  • Posts: 57
  • Karma: +7/-0
    • Zagreb, CROATIA
    • Embrio Production Studio
Re: SSL 4000 E Cut Problem
« Reply #3 on: January 13, 2020, 08:50:00 PM »
I had similar problem,and what I found..bad switch for 651 center section,losing -18V in centre. Check power switches under patchbay,maybe some of them had big resistance and voltage after switch is not correct.

Cheers,
Raf
Audioplatinum Service

Sent from my POCOPHONE F1 using Tapatalk

"A clean desk is the sign of a sick mind..."

WiktorTRS

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • mazowieckie
Re: SSL 4000 E Cut Problem
« Reply #4 on: January 17, 2020, 12:20:38 PM »
Thank you so much! I will check it in a couple days. Kindly regards!