The design dudes at CML are seriously considering making a channel test jig...... the decision is a balancing act of benefit versus cost.... yes, it's a useful thing to have, but is it worth the effort to do PCB(s) and put in a lot of effort to make a one-off for our workshop? We currently do module test in a 2-bucket mini-console. As a test-method, the mini-console works well, but is not as convenient as a jig on a bench.
If there was some real interest that would make the effort worthwhile, we could move this from an interest / nice-to-have project to a real project.
Comments will be appreciated.