Hi guys
So we finally completed fully cleaning of our newly acquired 4064G+. Very dirty indeed...
I made a small timelapse of part of the process on youtube:
http://youtu.be/Dh73Y4HNGIUThis video shows the cosmetic channel cleaning process as part of the refurbishment of the SSL 4064G+ in Frostbox Studios in Copenhagen.
The channel is seated in a slotted height adjustable table found in the scrapyard and rebuild with a new controller-part that was broken.
The process takes one an a half hour for two people per channel...
Simple description:
1: Remove all buttons using a fabric-taped plier.
2: Remove all the tops of the knobs carefully with a knife.
3: Reset all knob positions to default (the detent or fully counter clockwise).
4: Remove all knobs using a fabric-taped plier and the special knob screwdriver. Be careful not to change the positions of the knobs.
5: All buttons and knob heads goes into a ultrasound bath (cheap one approx: 50$). 40 kHz for 5 min. Pink knob heads less time and buss routing switches longer time.
6: Use a cloth to wipe off the last dirt.
7: Meanwhile step 5 & 6 is done by your collegue you clean the surface with baby wipes, then a small area with toothbruss and a small amount of water and soap, then Q-tips dipped in water and soap, then finally check with a baby wipe that its all clean.
8: Reseat the buttons and knobs in the default postition.
Then we blow air across the curciut boards downwards, clean the edge connector with isopropyl alchohol and Q-tips. Finally we used a contact cleaner for the two insert switches.