Hey hey.
Between dodgy program disks and issues with my G+ disk drive my computer hasn't been kind to me over the last few months. I've replaced the disk drive with a "new" one and reconfigured a new program disk to my console and all seems swell...... apart from one thing, the computer will not load a saved setup properly. I can "PLAY SETUP" and I can press "A" for TR AUTOSCAN and press EXECUTE twice for full channels but the knob, fader and switch positions are all over the place. Pressing a switch or turning a pot doesn't change the channel information displayed on the screen. I can successfully switch between channels using the fader status buttons and automation works absolutely fine.
Any ideas?
I've had a similar problem before when a cable at the rear of the keyboard was in the wrong place but nothing seems amiss this time.
Thanks very much.
Ash