SSlmixed.com Forum

Tech discussion => 4K,6K,8K Series => Topic started by: perfectsnd on May 24, 2016, 02:52:25 PM

Title: Computer Not Seeing Stereo Inputs
Post by: perfectsnd on May 24, 2016, 02:52:25 PM

I recently installed 5 stereo channels to my 4056 4000G that was loaded 48 mono, but I cannot get the computer to recognize the new channels.  The VCA are at full on all the time for the new stereo channels.  Is there a configuration I need to do to make these channels active on the console so that they have VCA control?

Channels 1-40 are one set of analog input/output cards and those work fine.  Channels 41-48 and the patch VCAs are on the second analog input/output card. If I switch the first analog card to the location of the second analog input/output card, my stereo channels, patch VCAs and 41-48 work fine.  If I switch the 2nd analog card to the first analog card slots, I only get control of the channels 1-8.

I am trying to figure out if this is a software configuration issue or if I have problems with my 2nd analog input/output card.

Thanks so much for the help.

Title: Re: Computer Not Seeing Stereo Inputs
Post by: perfectsnd on May 29, 2016, 08:21:32 AM

bump up to see if anyone has any answers.

Thanks.

Title: Re: Computer Not Seeing Stereo Inputs
Post by: ULH on May 29, 2016, 10:45:05 AM

Have you tried the custom console setup in the software? Read computer service manual page 1-17 to 1-20.

Cheers,
Uffe

Title: Re: Computer Not Seeing Stereo Inputs
Post by: Showcase on May 29, 2016, 10:53:38 AM

...there is also the "Stereo channels in use?" in the setup

Title: Re: Computer Not Seeing Stereo Inputs
Post by: perfectsnd on May 30, 2016, 01:42:11 PM

I unfortunately don't have the computer service manual. Can anyone post the pages mentioned above?

Title: Re: Computer Not Seeing Stereo Inputs
Post by: Showcase on May 30, 2016, 02:01:59 PM

Quote from: perfectsnd on May 30, 2016, 01:42:11 PM

I unfortunately don't have the computer service manual. Can anyone post the pages mentioned above?

Did you activate "stereo channels" in the setup?

Title: Re: Computer Not Seeing Stereo Inputs
Post by: ULH on May 30, 2016, 07:38:21 PM

You can buy the manual right here on this forum: http://forum.sslmixed.com/index.php/topic,428.0.html

Title: Re: Computer Not Seeing Stereo Inputs
Post by: Clip6 on June 01, 2016, 11:30:00 PM

Just looked in computer service manual. You have custom and standard maps. You added a bucket or just replaced mono channels with stereo channels?
Yea you should get the service manual if it's a copy of what you get with the console it's full of great info.

If you add a bucket to your console you need to tell the computer. These are the steps.

SETUP (ex) M—–C—–O.