SSlmixed.com Forum

Tech discussion => 4K,6K,8K Series => Topic started by: lukeaudio on October 26, 2017, 04:41:38 AM

Title: S3E Pinout
Post by: lukeaudio on October 26, 2017, 04:41:38 AM

hello someone has the schematic of this connector  :  S3E ribbon connector Pinout  FOR SSL 8000 Gb
thank

Title: Re: S3E Pinout
Post by: amillar on October 31, 2017, 06:25:28 PM

I've got it for a 4000, I wouldn't have thought the 8k would be different?

• Slate Signal bus
• Not used?
• VCA to Mon bus
• Slate Control bus
• Ch Solo cut bus
• Not used?
• Status mix bus
• Master Input Flip
• Mon Solo cut bus
• Not used?
• Machine Record bus
• Master Ready Group
• Status Record bus
• Not used?
• Solo disable
• VCA to meters bus
• 0V
• Cue 3 Mix bus
• Cue 4 Mix bus
• 0v

The "Not used?" may have been used for 8000 functions, pins 2 and 6 are bus "C" L & R on the 6000.

Hope that helps a bit...

Cheers, Andy

Title: Re: S3E Pinout
Post by: lukeaudio on October 31, 2017, 07:21:22 PM

bello AMILLAR .. thank you very much for answering

Title: S3E Pinout: Ribbon OR hardwired pinouts
Post by: jimlfixit on November 14, 2017, 06:09:43 PM

Please bear in mind that any pinouts seen in the SSL manuals for those D connectors that use internal ribbon cable (at least) are for ribbon cable pinouts and NOT hardwired versions.
Therefore pin 1 is the same for both but pin 2 for a ribbon connector would be 14 on a hardwired connector.
Hardwired pinouts go from 1 to 13 ALONG one row and then 14 to 25 on the other row.
Ribbon pinouts go 1 (both ribbon and hardwired), 2 (is 14 hardwired), 3 (is 2 hardwired), 4 (is 15 hardwired) and alternate between the rows as the ribbon cable is flat and has to correspond to the pins on a hardwired (solder type) connector.
I will post something in the wiring menu on this shortly and hope this makes sense.