SSlmixed.com Forum
Tech discussion => 4K,6K,8K Series => Topic started by: StefanNowak on November 15, 2012, 05:50:15 AM
-
Still troubleshooting Total Recall here.
My console is a dual I/O setup, I would like to try it running off a single I/O however whatever I do it just refuses to boot up as a single I/O system, the computer constantly reports that the 2nd I/O can't be found. I set the software correctly, I take the 2nd I/O out of the computer completely and even disconnect the interface connectors... but still the computer reports the 2nd I/O can not be found.
Is there something I'm missing? is there somewhere deeper in the software? I've looked at the maintenance page ie SSL, 4100, SETUP, # and there is nothing there.
Changes to I/O are only found at SETUP, M, C.
Stef.