SSlmixed.com Forum

Tech discussion => 4K,6K,8K Series => Topic started by: StefanNowak on October 23, 2013, 06:37:18 AM

Title: Labelling a 112point patchbay
Post by: StefanNowak on October 23, 2013, 06:37:18 AM

Howdy,

I still have a temp label masking taped on an empty bay below my outboard patch bay. I've tried a few spreadsheets but haven't had any luck.

Any ideas?

Title: Re: Labelling a 112point patchbay
Post by: marcmozart on October 23, 2013, 08:19:09 AM

Jim Lassen will know all about this.

Title: Re: Labelling a 112point patchbay
Post by: StefanNowak on October 23, 2013, 08:21:25 AM

Jim sent me something a while ago I tried tweaking but I can't seem to match it up.

I was hoping someone would have a template set up already.

Title: Re: Labelling a 112point patchbay
Post by: waltzingbear on October 23, 2013, 05:38:09 PM

what are you printing it out on?
I use  a P-Touch and it works great.

to set up your own templates TABLES are your friend.
set length to match the width you are printing and then number of cells to number of points, viola, template, fill in the cells.

Alan

Title: Re: Labelling a 112point patchbay
Post by: unitedreco on December 13, 2013, 03:22:16 AM

attached you will find a patch label prog by neutrik....unzip and run ...il post a setup i did for the ssl bay works perfect...you can just delete the names and add your own til you figure it out

Title: Re: Labelling a 112point patchbay
Post by: unitedreco on December 13, 2013, 03:26:37 AM

heres the file you can use to get right to work open it with the above prog i attached