SSlmixed.com Forum
Tech discussion => 4K,6K,8K Series => Topic started by: christiancarvin on February 16, 2014, 05:54:12 PM
-
What are we supposed to with Test points?
Is there a general procedure or a specific procedure for each card/test point?
Is there any documentation available on that?
Thanks!
-
The 611E line-up procedure is in the Technical Documents section of the Forum.
-
Thanks Kevin,
But I can't see where those TPs are mentionned on the 611....
Would you give me some precision?
-
They are on the daughter cards depending on what is being aligned. Usually the TP and pot in question are on the same card. Study the signal flow of the channel, get to know it like "the long way home" and you will find the proper test points.
Mike
-
Thanks Michael,
I must admit that I'm not that good in reading schematics...
But I'm trying as hard as I can!!
-
Start with the channel block diagram it should be a large sheet in the manual and it is not a schematic. If you do not have one then the manual download here has it and it is the best 10 euros you can spend and it helps the forum.
One way to try and make sense is to make a copy or print of the block and use different color highlighters to trace different routes around the page. It is daunting to decades long techs as well and everyone has a different way of wrapping their head around it.
Mike
-
Thanks Mike! I appreciate your help :D!
I'll try that!
-
Dear ssl friends!
Here is my first real contribution to this forum...(until that point I was only asking help and advices because of my low skill)
But thanks to you I improve my self.
I hope this document will help people like me who don't know about TPs!
(http://img15.hostingpics.net/thumbs/mini_281983IMG0537.jpg) (http://www.hostingpics.net/viewer.php?id=281983IMG0537.jpg)
-
Goodonya!
That's what it is all about.
-
Good one Chris!! ;)