Author Topic: EQ in and/or Split in cuts signal in the channel ------SOLVED------  (Read 8270 times)

Dave Dicson

  • Jr. Member
  • **
  • Posts: 53
  • Karma: +2/-0
Re: EQ in and/or Split in cuts signal in the channel
« Reply #15 on: February 20, 2025, 04:07:10 PM »
I have not had any trouble with the Filter pots. Sorry I don't remember which ones. probably level? I'm not sure which Eq you have, but the G series Eq has four sections. If any one of those sections has bad pot(s), they will kill the signal when the Eq is turned on. I have three 4K SSL consoles, and it has happened too me, but not very often. I've had pots that grind when turned.
« Last Edit: February 20, 2025, 04:12:56 PM by Dave Dicson »

Chris Simon

  • Full Member
  • ***
  • Posts: 102
  • Karma: +6/-0
Re: EQ in and/or Split in cuts signal in the channel
« Reply #16 on: February 20, 2025, 04:36:15 PM »
Don't neglect the Dynamics switch card, particularly the Channel Out switch. Given that this switch changes the order of Dynamics and EQ, I believe the EQ'd signal needs to pass through this card as well, regardless of whether the switch is pressed or not.

oyanliz

  • Full Member
  • ***
  • Posts: 209
  • Karma: +1/-0
Re: EQ in and/or Split in cuts signal in the channel
« Reply #17 on: February 22, 2025, 08:08:54 PM »
Hi,

Thanks to all one more time!! I would not be able to do all maintenance work in my loved SSL4040E. I finally could fix the channel 31!!

This channel is one of eight SL611G fited in my console.

I have started replacing the frequency pot of HMF section, after cheking the Dynamics switch card (as suggested Chris in his post).

The first pot replaced... I was testing if something have changed... and when I was testing... I have touched the +15/-15 trim pot of HMF.

I have realized that touching one of the pole of the pot... signal was coming!!

I have removed the covering plastic of the pot... and I could see one of the two white cables was peeled and touching the other pole! It is crazy!

So I have added a new heat shrink piece to the peeled cable and a bigger diameter trasnparent heat shrink for protecting all pot poles pins.

The pot works fine, the issue was the short between these two poles.

I have attached some photos as info for anyone who could have a simillar issue in the future.

Thanks to all for the support and help offered in this forum.

Very best regards.

Oihan

gertius

  • Jr. Member
  • **
  • Posts: 56
  • Karma: +2/-0
Re: EQ in and/or Split in cuts signal in the channel ------SOLVED------
« Reply #18 on: February 23, 2025, 07:40:54 AM »
Great detective work!

Congratulations on fixing the channel and thanks for sharing your solution.

Best,
Christian

horizonsound

  • Sr. Member
  • ****
  • Posts: 374
  • Karma: +22/-0
    • Melbourne, Australia
    • Horizon Sound
Re: EQ in and/or Split in cuts signal in the channel ------SOLVED------
« Reply #19 on: February 23, 2025, 08:27:16 PM »
That's a new one I have not seen before.

Well done finding it.

Anthony/