Small fader black screws

[Nick]

Hi ,

can anyone tell me where I can find the small black screws that hold the small fader to the panel of the channel?
Is there a preferred source for that kind of screws ?

Thanks

Nick

[marcmozart]

Hi ,

can anyone tell me where I can find the small black screws that hold the small fader to the panel of the channel?
Is there a preferred source for that kind of screws ?

Thanks

Nick

+1 looking for these as well
also can anybody point me to the tool needed for these screws?

[sintech]

This is the correct tool, should be easy to find at RS.

Note, for the small fader these 6BA screws need too be longer than 3/16th’s

[marcmozart]

Thanks!

Where did you get the screws from?

[sintech]

Thanks!

Where did you get the screws from?

http://www.ajreeves.com/6ba-socket-csk-screws-10-9587-p.asp

[sintech]

Ok.. just checked, and these work fine on a G series module. How many do you need? The 3/16th size is a bit of a fiddle on the E series, last time I tried.

[Nick]

Thanks sintech,
but i see that small fader scews are about 2,5 mm.
I thinks this is equivalent of 1/4".
Am i correct ?
So i was assuming that small faders screw for E/G serie is 6BA 1/4" , 6mm long

[marcmozart]

Thanks! Not urgent - I will order some. Just want to have them in the spares corner so that I can replace them with new ones as I go through cleaning my small faders!

Ok.. just checked, and these work fine on a G series module. How many do you need? The 3/16th size is a bit of a fiddle on the E series, last time I tried.

[sintech]

Thanks sintech,
but i see that small fader scews are about 2,5 mm.
I thinks this is equivalent of 1/4".
Am i correct ?
So i was assuming that small faders screw for E/G serie is 6BA 1/4" , 6mm long

Yes, measures 1/4" also.

[michaeldtech]

One thing to remember before attempting a removal on an old console- the screws are slightly fused to the paint so you want to give them a "whack" to break the bond. I use a small nail head or a piece of 1/8" rod. A few light taps are all you need and the screws turn easily.
Mike