Author Topic: Computer problem, video link inside SOLVED (Read 6763 times)

Showcase · « **on:** September 08, 2015, 03:30:10 PM »

HI!

I hope as someone can help us out here, today when we came down to studio keyboard was bleeping contsantly, no reboot did it either, it loads up fine though but ye...
I provide a link to a video http://www.dreamix.se/Fault.mp4

* checked cables, reseated some cards in computer
* reseated cleaned all chips on the keyboards card plus recapping

Any tip would be awesome! / Mattias

mikelleroy · « **Reply #1 on:** September 08, 2015, 04:56:43 PM »

Sounds very familiar to me,
had this twice and was a blocked (stickey) key on one of the keyboards.
Make sure all your keyboard switches are free moving and not stuck.
Hope this helps,
Good Luck!

sintech · « **Reply #2 on:** September 08, 2015, 05:16:29 PM »

With the stuck key, you don't get the repetitive beep.. that's been my experience so far.

Showcase · « **Reply #3 on:** September 08, 2015, 05:18:00 PM »

Ye its not a stuck key sadly I know for 100% now after further testing

sintech · « **Reply #4 on:** September 08, 2015, 05:20:59 PM »

so what do you suspect the most, the keyboard, or the Keyboard/VDU interface card?

Showcase · « **Reply #5 on:** September 08, 2015, 05:53:45 PM »

The keyboard card in the computer.

If it should have been the keyboard, wouldnt the computer still "take control" over the VCA in and out when loading was done? it seems it stucks after loading in my second disc and then I get this

sintech · « **Reply #6 on:** September 08, 2015, 06:43:31 PM »

Yeah, you're right.. the computer will load and take control of the VCA's with no keyboard attached.

Have a tested spare Keyboard/VDU interface card if your stuck.

Showcase · « **Reply #7 on:** September 09, 2015, 09:14:38 AM »

Thanks for the help

There is at least one problem in keyboard VDU card since the ribbon cable brunt out Line 4 and 7

I only have a handwritten schematic to this card, anyone has a better one perhaps?

walrus · « **Reply #8 on:** September 09, 2015, 12:08:33 PM »

Is this it??

Showcase · « **Reply #9 on:** September 09, 2015, 08:00:01 PM »

Thanks for the help, still struggling but Andy helped alot during the day and its moving forward

Thanks walrus for the schematic

Showcase · « **Reply #10 on:** September 28, 2015, 02:58:38 PM »

This problem is solved!

Bad program disc!
For any of you who watched the video it do seems everything is loading correct in the boot, at the end it switches over to the other disc and loads it, then started blipping!

I never suspected the disc because we keep the console on 24h mostly and this behavior was there when we arrived to the studio, but probably there must have been a power failure causing the console to reboot during the night and then ofcourse the problem had to appear

SSlmixed.com Forum

News: