Cuts affected by Total Recall

[billythekid]

Thank you for the suggestion!

Alright so I'll swap out 50 way ribbons to see if it could be one of the ribbons within the console and then inspect the bucket's channel module PCB.

Don't know if I should have mentioned this earlier, but this is an ultimation console if that changes anything.

[billythekid]

Hey all, so the issue has been resolved!!! I wanted to come back and let everyone know what the problem ended up being and how grateful I am to this community for the energy spent in trying to help me out!

After switching every module and card in the bucket, I was at a complete loss. It was suggested to check the voltages running to the fader bus card. On the audio rainbow ribbon, pin 1 (brown) was reading 12.5 instead of 15. After chasing that rainbow ribbon cable it ended up being an intermittent connection between this ribbon and the connector to the power that was causing the problem. Soon as I got 15v the problem would go away, it must have been to weak a signal or something.

Thanks again to all that chimed in!!!

[kilmister]

Great you found it!

Did this solve also your "all pots at CW" problem with TR?

-Paavo

[billythekid]

One channel that was being affected by the fader was due to a problem in the ribbon that ran between the card and fader. Messing around under the keyboard is basically what resolved it for the whole console. I believe adding a couple jumpers to the Keyboard Interface card is what ended up doing it.