Console finally upright …..

[horizonsound]

Yep that's the way E channels behave.
They have different design logic cards
I never noticed until now.
My current console is a split 8000 G with 8x 4000 E channels

Anthony

[Jdm5149]

Been busy troubleshooting and have gotten very far. Board really looks and sounds great. Trying to figure this one out. In mix enabled with computer running only 1-16 and vca 1-8 light up for automation. After a bunch of options I then swapped 17-24 to slot 1-8 and 17-24 lite up on the console.  I already swapped out the computer card with another so it’s something other than the lights/switch’s card. Any suggestions.  Thanks !!

[horizonsound]

Have sent you an email.

[Jdm5149]

I’ve been troubleshooting and swapping channels around. Would all the multiplex cards need to be reset with their jumpers. I’m assuming so in order for total recall to work. Would that affect the automaton ??

[Dave Dicson]

Yes, All the jumpers need to be switched, unless they have already been switched. The dip switches on the multiplex cards on all modules need to be set to different addresses. The address chart is in the manual.

[Jdm5149]

Thanks.  I’ve been swapping channels around to test and get things to work. So I’m sure I gotta read the manuals at some point  lol.  Thanks again !